2. Place the two other strips of tape on the ends of the sensor disk, perpendicular to the first
piece of tape and parallel to the cable then rub the tape surface into the module surface.
See the following figure.
FIGURE 7-2. Proper tape usage
7.3 Wiring
(p. 11) provides the schematic and
(p. 11) provides the connections to
Campbell Scientific data loggers. Either a 4-wire half bridge or 3-wire half bridge configuration
can be used to measure the 110PV. The 4-wire half bridge configuration is preferred because it
reduces cable errors. The 3-wire half bridge configuration uses fewer terminals.
110PV Surface Temperature Probe
10