![background image](http://html1.mh-extra.com/html/campbell-hausfeld/in470200av/in470200av_operating-instructions-and-parts-list-manual_3862558004.webp)
4
Pressure Washer
www.chpower.com
Safety Guidelines
This manual contains information that is very important
to know and understand . This information is provided for
SAFETY and to PREVENT EQUIPMENT PROBLEMS . To help
recognize this information, observe the following symbols .
danger indicates an imminently
hazardous situation which, if not
avoided, wIll result in death or serious injury.
warning indicates a potentially
hazardous situation which, if not
avoided, Could result in death or serious injury.
Caution indicates a potentially
hazardous situation which, if not
avoided, MAy result in minor or moderate injury.
notice indicates important information,
that if not followed, may cause damage
to equipment.
NOTe:
Information that requires special attention .
CALIFOrNIA PrOPOSTION 65
This product or its power cord
contains chemicals known to the state
of California to cause cancer and birth defects or other
reproductive harm. wash hands after handling.
Important Safety Instructions
SAve THeSe INSTruCTIONS
When using this product, basic precautions should always be
followed, including the following:
1 . Read all instructions before using the product .
2 . To reduce the risk of injury, close supervision is necessary
when the product is used near children .
3 . Follow all safety codes as well as the Occupational Safety
and Health Act (OSHA) .
4 . Ensure safety devices are operating properly before each
use . DO NOT remove or modify any part of the gun or
unit .
5 . Know how to stop this product and bleed pressure quickly .
Be thoroughly familiar with the controls .
6 . Stay alert – watch what you are doing .
7 . Do not operate the product when fatigued or under the
influence of alcohol or drugs .
8 . Keep operation area clear of all persons .
9 . Do not overreach or stand on unstable support . Keep
good footing and balance at all times .
10 . Follow the maintenance instructions specified in the
manual .
risk of injection or severe injury.
Keep clear of nozzle. do not discharge
streams at persons. This product is to be used only by trained
operators. Always remove lance from gun before cleaning
debris from tip.
• Keep clear of nozzle. NEVER direct high pressure spray at
a person, animal, or yourself .
• Always wear safety glasses or goggles and protective
equipment (hearing protection, gloves, rubber boots,
protective clothing) when operating or performing
maintenance .
• Never put hand or fingers over the spray tip while
operating the unit .
• Never try to stop or deflect leaks with any body part.
• Always engage the trigger safety latch in the safe position
when spraying is stopped even if only for a few moments .
• Always follow detergent manufacturer’s label
recommendations for proper use of detergents . Always
protect eyes, skin, and respiratory system from detergent
use .
do not use pressure that exceeds
the operating pressure of any of the
parts (hoses, fittings, etc.) in the pressurized system. ensure
all equipment and accessories are rated to withstand the
maximum working pressure of the unit.
explosion hazard.
• NEVER spray flammable liquids or use pressure washer in
areas containing combustible dust, liquids, or vapors .
• Never operate this machine in a closed building or in or
near an explosive environment .
• Do not remove fuel tank cap or fill fuel tank while engine
is hot or running (allow engine to cool two minutes
before refueling) . Always fill the tank slowly .
• Never disconnect the high pressure discharge hose
from the machine while the system is pressurized . To
depressurize machine, turn power and water supply off,
then press the gun trigger 2-3 times .
• Never permanently engage the trigger mechanism on the
gun .
• Never operate the machine without all components
properly connected to the machine (handle, gun/wand
assembly, nozzle, etc .) .
equipment damage.
• ALWAYS turn water supply “ON” before turning pressure
washer “ON .” Running pump dry causes serious damage .
• Do not operate the pressure washer with the inlet water
screen removed . Keep screen clear of debris and sediment .
• NEVER operate pressure washer with broken or missing
parts . Check equipment regularly and repair or replace
worn or damaged parts immediately .
• Use only the nozzle supplied with this machine.
• Never leave the wand unattended while the machine is
running .
• Never tamper with the engine governor or attempt to
alter factory settings . Altering factory settings could
damage the unit and will void the warranty .
• Always hold gun and wand firmly when starting and
operating the machine .
• NEVER allow the unit to run with the trigger released (off)
for more than one minute . Resulting heat buildup will
damage the pump .
• NEVER store the pressure washer outdoors or where it
could freeze . Freezing temperatures can seriously damage
the pump .
• Release the trigger when changing from high to low
pressure modes . Failure to do so could result in damage to
the nozzle .
Keep hose away from sharp objects.
bursting hoses may cause injury.
examine hoses regularly and replace if damaged. do not
attempt to mend a damaged hose.
Safety and Warning Information