50
Autowbrake Controller Adjustment
Check current setting anytime by pressing the gain/right button on
Autowbrake controller. For Camp-Inn trailers, it should be on
Setting 1
.
It should not need adjustment, but if it does...
1.
Press and hold the brake pedal.
2.
Press the gain/right button to increase setting.
3.
Press the calibrate/left button to decrease setting.
4.
Once set, release brake pedal. The last setting will be saved for
future use.
Flash settings:
Setting 1: 1 slow flash 3 times in a row (total 3 flashes)
Setting 2: 2 slow flash 3 times in a row (total 6 flashes)
Setting 3: 3 slow flash 3 times in a row (total 9 flashes)
Autowbrake Key Fob
The key fob provides you the ability to make subtle changes in braking
force. These changes may be made in motion or when stopped, any time
the trailer is connected. Up button is used to increase braking force and
Down button is used to decrease braking force.
There are 5 brake force levels available.
1.
At a complete stop: Press brake pedal and use Up/Down buttons
to increase or decrease the braking force.
2.
In motion: Lightly press the brake pedal and use the Up/Down
buttons to increase or decrease the braking force.
3.
If you are not sure where you are at 1-5, Press the Down button 5
times to move to the #1 level. Then push the Up button the
number of times needed to get to the desired level.
To check the power level, press the left button on the Key Fob. LED
will flash. Count the flashes to determine the current level.
On dry pavement, you may adjust the brake force higher. On gravel or
wet pavement adjust the braking force down. On ice or snow, set the
brake force at the lowest setting. If the trailer brakes lock-up when
applied, they are set too high.
To manually apply trailer brakes:
Press any button on the
key fob. You should feel the trailer brakes engage. Hold button down as
long as you want the trailer brakes applied.
