Operation and maintenance instructions
Series PRE proportional pressure regulator
IO-Link version
5000030186
Ver. 03
30
13.2.1.
Unit of measurement (pressure sensor)
Displays the unit of measurement of the pressure sensor and can take on the following values:
0 = psi.
1 = bar.
2 = kPa.
13.2.2.
Minimum regulated pressure
Sets the minimum target pressure accepted by the Regulator, in case the value should be lower
than the value stated in this parameter, the Regulator will give a warning without making any
adjustment.
This parameter must have a positive value and be less than the "Maximum target pressure"
parameter.
13.2.3.
Maximum regulated pressure
Sets the maximum target pressure accepted by the Regulator, in case the value should be higher
than the value stated in this parameter, the Regulator will give a warning without making any
adjustment.
This parameter must be higher than the
“Minimum
target
pressure”
parameter and must not
exceed the
“
M
aximum pressure”
parameter.
13.2.4.
Pressure switch control
Enables the
“Pressure Switch”
control on the pressure reading and can be
0 = Disable or 1 = Enable.
This control allows to define a lower and an upper threshold, in case the regulated pressure falls
out of the range established by these two thresholds, the Regulator will give a warning, but will
not interrupt the regulation.
In this case the diagnostic led will not change its state.
This is a useful way to verify if the regulated pressure lies within the pre-established range or
not.
