Operation and maintenance instructions
Series PME proportional pressure regulator
5000044242
Ver. 01
4
2.
Introduction
This manual illustrates how to properly use the
Series PME electronic pressure regulator
.
This version of the Controller is identified with code 0184 xx xx xxx x xxxxx, where 0184 indicates
the version of regulator and is followed by year, week, machine, station and serial number.
3.
General recommendations
The recommendations regarding safe use in this document should be observed at all times.
•
Some hazards can only be associated with the product after it has been installed on the
machine/equipment. It is the task of the final user to identify these hazards and reduced the
associated risks accordingly.
•
The products dealt with in this manual may be used in circuits that must comply with the
standard EN ISO 13849-1.
•
For information regarding component reliability, contact Camozzi.
•
Before proceeding with use of the product, carefully read all information in this document.
•
The instructions in this manual must be observed together with the instructions and
additional information regarding the product in this manual, available from the following
reference links:
o
o
Camozzi general catalogue
o
Technical assistance service
•
Assembly and start-up operations must be performed exclusively by qualified and authorized
personnel on the basis of these instructions.
•
It is the responsibility of the system/machine designer to ensure the correct selection of the
most suitable pneumatic component according to the intended application.
•
For all situations not contemplated in this manual and in situations in which there is the risk
of potential damage to objects, or injury to persons or animals, contact Camozzi for advice.
•
Never make unauthorized modifications to the product. In this case, any damage or injury
to objects, persons or animals will be the responsibility of the user.
•
All relevant product safety standards must be observed at all times.
•
Never intervene on the machine/system before verifying that all working conditions are safe.
•
Before installation and maintenance, ensure that the specific envisaged safety locks are
active, and then disconnect the electrical mains (if necessary) and system pressure supply,
discharging all residual compressed air from the circuit and deactivating residual energy
stored in springs, condensers, recipients and gravity.
•
To reduce the noise levels caused by the discharge of air from the component, envisage the
use of silencers or convey the fluid to a zone where no personnel are envisaged during
normal operation.
•
Avoid covering the equipment with paint or other substances that may reduce heat
dissipation.
