Operation and maintenance instructions
Series PME proportional pressure regulator
5000044242
Ver. 01
16
•
PME1 series electronic regulator can be connected to DIN rails using the relative elements
PCF-E520 fitted on the rear of the body using two M4 threaded holes.
•
The Series PME electronic regulator can be directly fixed to a support using the 2 through
holes with diameter 4mm present on the body (not available in the PME1 manifold version).
•
The PME electronic regulator can be fixed to the wall with the optional bracket code PRE-ST:
1. Fix the bracket to the wall with suitable screws
2. Connect the fittings G1/4; G3/8 or NPTF according to the PRE regulator size
3. Connect the regulator to the bracket with the two M4 x 55 screws supplied
•
Make sure that the bracket is completely resting on the wall
•
Connection of Manifold regulators with related Kit PRE-M-Pin-1-2
1. Insert the pins (1) in the seats on the regulator body
2. Insert the O-ring seal (3) into the special seat on the side face of the body
3. Bring the two modules sideways up until contact
4. Tighten the four grub screws (2) until they are locked (Tightening torque: 2,5 ± 0,5 Nm)
