10
Recording Status and LED Confirmation
CAM 1,2,3,4
1. If the camera is connected, the corresponding LED light will
flash every second. (E.g. when only CAM 1 is connected, the
light for CAM 1 only will be on.)
2. CAM LED lights will not turn on if there is an issue with the
corresponding camera’s connection.
Booting
1. All LED lights turn on for 12 seconds after successfully booting. Then,
CAM 1 to 4 lights turn on for four seconds. CAM 1 to 4 lights will then
flash every second for five seconds, after which drive recording will start.
* Please check the power or SD card connection status if the device
does not boot within 30 seconds.
Recording Mode
1. CAM 1 to 4 LEDs will flash every second after recording starts.
2. If a shock (EVENT) occurs, the LEDs on CAM 1 to 4 flash
five times within a second from the start to the end of the
event.
Wi-Fi
1. The Wi-Fi LED will turn on when the Wi-Fi is connected (E.g. when
configuring FTP settings).
2. The Wi-Fi LED is turned off when the Wi-Fi is not connected.
3. The Wi-Fi LED flashes after connecting and when transmitting data.
MIC
1. The MIC LED will turn on when a microphone is connected.
2. The MIC LED will be off when a microphone is not connected.
GPS
1. When a GPS antenna is connected, it begins searching for a signal.
The GPS LED will turn on when the signal is received. The LED light
flashes every second when the signal reception is poor.
2. The GPS LED will be off when a GPS antenna is not connected.
