PM 1002308 000 00
Summation current transformer SIRAX CT6xx line
6/12
1. Legal information
1.1 Safety and warning notices
In this document safety and warning notices are used, which you have to observe to ensure personal safety and to prevent damage to property.
If the warning notice is not followed death or severe personal injury
will
result.
If the warning notice is not followed damage to property or severe personal injury
may
result.
If the warning notice is not followed the device
may
be damaged or
may
not fulfill the expected functionality.
The installation and commissioning should only be carried out by trained personnel.
Check the following points before commissioning:
- that the maximum values for all the connections are not exceeded, see „Technical data“ section,
- that the connection wires are not damaged, and that they are not live during wiring,
- that the power flow direction and the phase rotation are correct.
The instrument must be taken out of service if safe operation is no longer possible (e.g. visible damage). In this case, all the connections must
be switched off. The instrument must be returned to the factory or to an authorized service dealer.
It is forbidden to open the housing and to make modifications to the instrument. The instrument is not equipped with an integrated circuit brea-
ker. During installation check that a labeled switch is installed and that it can easily be reached by the operators.
Unauthorized repair or alteration of the unit invalidates the warranty.
Please observe that the data on the type plate must be adhered to!
The national provisions have to be observed in the installation and material selection of electric lines!
Table of Contents
1. Legal information ………………………………………………………………………………………………………… 6
1.1 Safety and warning notices ………………………………………………………………………………………………… 6
1.2 Qualified personal ………………………………………………………………………………………………………… 7
1.3 Intended use ……………………………………………………………………………………………………………… 7
1.4 Disclaimer of liability ……………………………………………………………………………………………………… 7
1.5 Feedback ………………………………………………………………………………………………………………… 7
1.6 Repair work and modifications …………………………………………………………………………………………… 7
1.7 Calibration and new adjustment …………………………………………………………………………………………… 7
1.8 Disposal ………………………………………………………………………………………………………………… 7
1.9 Return …………………………………………………………………………………………………………………… 7
2. Introduction ……………………………………………………………………………………………………………… 7
2.1 Purpose of this document ………………………………………………………………………………………………… 7
2.2 Scope of supply ………………………………………………………………………………………………………… 8
2.3 Further documents ……………………………………………………………………………………………………… 8
3. Functional description …………………………………………………………………………………………………… 8
4. Assembly and installation ……………………………………………………………………………………………… 8
5. Electrical connections …………………………………………………………………………………………………… 8
6. Technical specifications ………………………………………………………………………………………………… 9
7. Identification of the type label ……………………………………………………………………………………………10
8. Sign explanation …………………………………………………………………………………………………………10
9. Dimensions drawings ……………………………………………………………………………………………………10
