Camille Bauer 175267, Руководство пользователя

Страница: 19 / 33

PM 1000288 000 00 Device handbook SIRAX BT5100 19/32
ON O/P1 O/P2 COM
ON O/P1 O/P2 COM
INPUT x012
O/P 12 y012
A
A
INPUT
*
INPUT x012
O/P 12 y012
A
A
INPUT
ON O/P1 O/P2 COM
ON O/P1 O/P2 COM
ON O/P1 O/P2 COM
O/P 1
A
O/P 1
A
*
O/P 1
A
*
Pressing the “ Down” key will enter the “New/Change
End value of the Output 1 edit” mode.
Pressing “ Up” key will confi rm the present value as End value of the Output 1 and advance to the Start
value of Output 1 (section 7.1.6.1.2).
New / Change End value of the Output 1
(*Denotes that digit will be fl ashing).
Pressing the “ Down” key will scroll the value of the fi rst digit from 0 through to 2, the value will wrap
from 2 round to 0.
Pressing the “ Up” key will advance the operation to the next digit and set the fi rst digit, in this case to
“1”.
Enter New / Change End value of the Output 1, fi rst digit entered, prompting for second digit. (*Denotes that
digit will be fl ashing).
Pressing the “ Down” key will scroll the value of the second digit from 0 through to 9, the value will wrap
from 9 round to 0, if fi rst digit is set to 1.
Pressing the “ Up” key will advance the operation to the next digit and set the second digit, in this case to
“8”.
7.1.6 Output parameter selection
7.1.6.1 Output 1 parameter selection
7.1.6.1.1 End value of output 1
This screen allows the user to set the End value of Output 1 (considerd as DC Current).
The End value of Current Output can be set up to 20mA.
Enter New / Change Elbow value of the Input, third digit entered, prompting for fourth digit. (* denotes that
digit will be fl ashing).
Pressing the “ Down” key will scroll the value of the fourth digit from 0 through to 9, the value will wrap
from 9 round to 0 depending on set value of End value of Input.
Pressing the “ Up” key will advance the operation to the “New / Changed Elbow value of the Input” and
set the fourth digit, in this case to “0”.
New/changed Elbow value of the Input confi rmed.
Pressing the “ Down” key will re-enter to the “New / Change Elbow value of the Input”.
Pressing the “ Up” key will confi rm New Elbow value of the Input and advance to the Output parameter
selection (section 7.1.6).