Cameron NUFLO 1141C, Руководство пользователя

Страница: 112 / 120

Scanner 1141 Hardware User Manual
112
mainboard. A detailed description of the switch settings for each interface is given in the mainboard
Pulse Input section.
Analog Output Switch
The analog output slide switch selects between 1-5V mode (left-hand position) and 4-20 mA mode
(right-hand position). In voltage mode, power is applied between the Ano+ and Ano- terminals with
the 1-5V output signal on terminal Vout (relative to Ano-). In current mode, the circuit operates as a
two-wire device that controls the current flowing from Ano+ to Ano-. In this case, Vout is not used.
MIO2 Expansion Board Installation
The following procedure should only be performed by a trained technician in a NON-HAZARDOUS
area.
1. Use ScanWin to download all configuration, calibration and historical data from the Scanner
RTU.
2. Turn off the Scanner 1141 RTU by moving switch SW11 to the “down” position.
3. Disconnect the power supply to the Scanner 1141.
4. Remove screws or standoffs as follows:
•
For the 1141G, remove the cover plate and four lower standoffs.
•
For the 1141C and 1141L enclosures, remove the four lower screws that hold the mainboard.
5. Install 6-32 x 7/16-in. standoffs on the four lower mounting holes of the mainboard.
6. Remove the MIO2 board from the anti-static bag and install it on the expansion connectors on the
mainboard (CN2 and CN16).
7. Reinstall screws or standoffs as follows:
•
For the 1141G, install four shorter standoffs and the cover plate.
•
For the 1141C and 1141L enclosures, reinstall the four screws.
8. Reconnect the power to the Scanner 1141.
9. Turn ON the Scanner 1141 RTU by moving switch SW11 to the “up” position.
10. Go to the Scanner Hardware page and verify that the resources are all recognized.
11. Configure any new features and test.