5
DMX
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
CONNECTIONS, CONTROL AND DISPLAY ELEMENTS
1
POWER IN
TRUE 1-compatible input socket. Operating voltage: 100–240 V AC / 50–60 Hz.
2
POWER OUT
TRUE1-compatible output socket to supply power to additional CAMEO spotlights. Ensure that the total
power consumption of all devices connected to the device does not exceed the given ampere (A) value.
3
FUSE
Fuse holder for 5 x 20 mm micro fuses. IMPORTANT NOTE: Exclusively replace the fuse with a fuse of the same type and values
(T3,15A/250V). If a fuse trips repeatedly, please contact an authorized service center.
4
DMX IN
Male 5-pin XLR connector to connect a DMX control device (e.g. DMX console).
5
DMX OUT
Female 5-pin XLR connector to transmit the DMX control signal.
6
OLED DISPLAY
Display for the currently active operating mode and the menu items in the processing menu.
7
DIM / ENTER / SELECT
Push button rotary encoder to set and control the spotlight.
DIM
- When used in CCT, HSI, Direct LED, Gel, User Color or Play Loop stand-alone mode, the encoder serves as a master dimmer (rotary encoder).
ENTER
- 1. Pressing ENTER brings you to the menu level to select the mode. 2. This navigates you one level deeper
into the menu structure. 3. Confirm the new value, such as a change to the DMX address, by pressing ENTER
SELECT
- Rotate the encoder to select the menu item from the menu level and change the value within the menu item (such as DMX address).
8
The function of the center push button rotary encoder (rotate and press) is shown on the corresponding menu item at the center of the
display (middle row = rotate, lower row = press).
9
ESC
- If the press function on the right push button rotary encoder is not shown explicitly in the display, then pressing the encoder
navigates to the next higher menu level.
10
ZOOM
The adjustment knob for manually adjusting the beam angle is located on the right side of the housing. The yellow bell-shaped knob is
located directly opposite the adjustment knob and is used for manually adjusting the beam angle using an operating pole for crossbeam
installation. The adjustment knob and drive unit for the operating pole are mechanically connected to each other. The adjustment knob or
yellow bell-shaped knob can be turned to continuously adjust the spotlight beam angle between 53° and 17°, with the zoom tube on the
Fresnel lens moving in and out of the housing through a gear-and-pinion system. The further the zoom tube emerges from the housing, the
smaller the beam angle. A stopping mechanism is in place to prevent the tube from falling out of the housing.
物料名称
广州市亮艺照明设备有限公司
颜 色
物料编码
材 质
制表人
制表时间
批 准
审 核
第
1
页,
共
1
页
版
次
工
艺
要
求
19/07/02
零表面处理
备注
受控正本
受控副本
单位章
客户
适用机型
AH
AH-F240 TW GK
NO.
1
2
3
修改区域
修改内容
修改日期
-
1
、
2
、丝印效果清晰完整，轮廓无粗糙
3
、按比例设计排版
，
本档比例为
1:1
4
、丝印位置正确
丝印所有文字图案正确无误
潘通
429C
丝印
下盖移印
半光细黑砂
4010402429
3
1
2
4
5
6
7
10
8
9
