CAMEC ELITE PRO
®
2
EM305
Ref: ELITE PRO 2 EM305-0715Rev.A.
6
FOR PROFESSIONAL INSTALLATION ONLY. These instructions are for general guidance.
Installation procedures may vary depending on caravan type.
Working under a vehicle without appropriate support is extremely dangerous!
• Place the caravan on a hard, level surface. The
use of a lifting ramp or an assembly pit is ideal for
access and personal safety.
• Unpack all the components and check for the
presence of all parts (see package contents list
pg. 2). Write down, on the product warranty
registration card, the 10-digit serial number (this
is located on an aluminium plate on the side of
one of the motor units).
• Clean the area of your chassis where you need to
mount all components to ensure a good fitting.
• Make sure the caravan is prepared for
installation. Check before installation that
important areas, such as drains/spare tyre, etc.
do not cause any obstruction to the function of the
caravan manoeuvring system.
• Ensure both rollers are in the DISENGAGED
position (Fig. 5), as the unit will not fit
correctly otherwise (Note: when fully disengaged,
the pointer is positioned in the beginning of the
yellow area).
• Loosely assemble the left hand motor unit (1), right hand motor unit (2) and main cross bar (3) (Fig. 4). The nuts
(Fig. 4A), on the cross bar (3) to secure both motor units, must be no more than finger-tight at this stage.
Note:
In principle, the unit should be fitted in front of the caravan road wheels, but if fitting in this position is not
possible because of obstacles or a too high hitch ball weight, it is permissible to fit it to the rear of the wheels by
rotating the whole assembly (Fig. 4) by 180° degrees.
INSTALLATION - MECHANICAL COMPONENTS
Please refer to Fig. 3 for an overview of the whole assembly fully fitted.
• Fit the Chassis Clamp Plates (34) to the chassis using bolts (35),nuts (36), washers (37) and spring washers (38),
then loosely fit the two aluminum clamp plates (7) to the plates (34) (Fig.3 & 6) and attach. Use the bolts M10x60,
nuts M10 and washers M10 (8,17,18) and put them in the diagonal positioned holes of the aluminium chassis
clamp plates. Nuts must be no more than finger-tight.
• Assemble the pre-mounted manoeuvring system on the aluminium chassis clamp plates by using the two
U-shaped brackets (9), bolts M10x50, nuts M10 and washers M10 (16,17,18). Nuts must be no more than
finger-tight.
• Make sure that aluminium drive rollers of the motors are approximately on the same altitude as the centre (axle)
of the caravan wheel (0mm~40mm, see Fig. 5). As well make sure that between the top of the motor housing
and the floor of the caravan is minimal 20mm space to make sure the motors can move freely (see Fig. 3 & 5).
To compensate a possible unevenness (and lower the motors),
Camec Elite Pro
®
2
has a set of distance plates
available. One set can compensate 15mm. In total three sets can be used so that an altitude of 45mm can be
compensated.
