CAMEC ELITE PRO
®
2
EM305
Ref: ELITE PRO 2 EM305-0715Rev.A.
4
INTRODUCTION
INTENDED USE
SPECIFICATIONS
Congratulations on choosing the
Camec Elite Pro
®
2
EM305 caravan manoeuvring system. This has been produced
according to very high standards and has undergone careful quality control procedures.
By simply using the remote control handset you can move your caravan effortlessly into any position required within
operating guidelines. Soft start and soft stop technology allows you to manoeuvre your caravan accurately without any
shocks.
The caravan manoeuvring system consists of two 12V motor-power rollers, a 12V electronic control unit and a
remote control handset. To function, the motor-powered rollers must be engaged against the tyres of your caravan.
The
Camec Elite Pro
®
2
EM305 Caravan manoeuvring system is provided with an automatic engaging system. By
pushing two buttons on the remote control, both motor-powered rollers will make contact with the tyre. Once this is
done, the manoeuvring system is ready for opreation. The remote control will allow you to move your caravan in any
direction. You can even rotate the caravan on its own axis, without moving forwards or backwards.
Before proceeding with installation and starting to use the manoeuvring system, please read
this manual very carefully and be aware of all the safety instructions! The owner of the caravan
will always be responsible for correct use. Keep this manual inside your caravan for future
reference.
The
Camec Elite Pro
®
2
EM305 caravan manoeuvring system is suitable for single axle and double axle caravans.
Suitable only for L-profiled and U-profiled chassis with a chassis thickness between min. 2.8mm and max. 3.5mm.
Depending on the weight of the caravan, the manoeuvring system cannot overcome obstructions that are more than
about 2cm in height without assistance (please use wedges as a ramp).
The standard installation kit only provides parts for installing the caravan manoeuvring system within the
measurements given in Fig. 2.
Designation
Camec Elite Pro
®
2
EM305
Operational voltage
12 Volt DC
Average current consumption
30 Ampere
Maximum current consumption
120 Ampere
Speed
approx. 11cm per sec.
Weight (2 motor set)
approx. 33kg (exclusive battery)
Permissible overall Weight single axle (2 motors)
2000kg (1750kg on 18% gradient)
Permissible overall Weight double axle (2 motors)
2000kg (1750kg on 18% gradient)
Permissible overall Weight double axle (4 motors)
3000kg (2350kg on 18% gradient)
Minimum width (caravan/trailer)
1800mm
Maximum width (caravan/trailer)
2500mm
Maximum tyre width
205mm
Power source (battery)
LiFePO
4
: 12V, 20Ah (recommended
Camec Elite Pro
®
2
EM305) Lead acid: 12V, 80Ah (min.)
