CAME ZLJ14, Руководство по установке

Страница: 40 / 96

p.
16
- M
an
ua
l
FA
010
82
-E
N
- 0
2/
20
18 - © C
AM
E S
.p
.A
. - T
ra
ns
la
tio
n o
f t
he o
rig
in
al i
ns
tru
ct
io
ns
Menu 1st level Menu 2nd level Options Default
Adjusting the maneuvering speed, calculated as a percentage.
[Slow Down Spd.
%]
[10%] …… [50%] [50%]
Adjusting the slow-down speed, calculated as a percentage.
[Soft Start] [Disabled] / [Enabled] [Disabled]
After each opening and closing command, the leaves start at slowed down speed
for a few seconds.
[Amperom. Sens.] [Disabled] / [Enabled] [Enabled]
Obstruction detection sensitivity.
&
This functions does not appear if [ENCODER] is set in the[Config]menu, or if
an obstruction is detected the function will intervene, depending on the setting, in
the following way:
- [Timed LS] it stops the gate leaves during a maneuver;
- [Limit-switch] it inverts the gate leaf swing during a maneuver;
- [Slo Dwn.] it inverts the gate leaves during a maneuver and stops them only
during the slow-down;
- [OpLs-ClSlo.] it inverts the gate leaves during a maneuver and stops them only
during the closing slow-down.
When the function is disabled, it stops the gate leaves when the maximum voltage
threshold is exceeded.
[Amperom Run] [-
◦◦◦◦◦◦◦◦
+] [-
・・・・◦◦◦◦
+]
Adjusting the Amperometric sensibility.
&
You need to enable the [Amperon. Sens] .
[Slo.dwn. time]
function
[O s]
……
[30 s]
[20 s]
Leaf slow-down time before each end stop.
& This function appears only if the following slow downs are enabled,
[OpLs-
ClSloDwn] or [Timed LS] from the [Config] function .
[ENCODER] menu
& Only viewable if the corresponding function is selected in [Config] in the [FUNCTIONS] menu
[Sensitivity] [Enabled] / [Disabled] [Enabled]
Obstruction detection sensitivity.
[Swing Sens.]
[-
◦◦◦◦◦◦◦◦
+] [-
・◦◦◦◦◦◦◦
+]
Obstruction detection sensitivity during gate swing (both opening and closing).
&
You need to enable the [Sensitivity] in the [ENCODER] menu .
[Slodwn. Sens.]
[-
◦◦◦◦◦◦◦◦
+] [-
・◦◦◦◦◦◦◦
+]
Obstruction detection sensitivity during slow-down (both opening and closing).
& You need to enable the [Enc. Slodwn.] function in the [ENCODER] menu .
[Enc. Slwdwn.] [ON] / [OFF] [ON]
Enabling the opening and closing slow-down starting points.
[Op.Slo. %]
[1%]
……
[40%]
[10%]
Setting the slow-down starting point before the opening limit-switch, calculated
as a percentage of the complete gate swing.
&
This function only appears if the [Enc. Slodwn.] function in the [ENCODER]
menu
.
[CL. Slwdwn%] [1%]
……
[40%] [10%]