Pa
g.
1
9
19
-
Ma
n
u
al
c
od
e:
3
1
9
U
17
31
9
U
17
ve
r.
1
.2
1.
2
04/2
0
10
9 © C
A
M
E c
an
ce
lli
auto
m
ati
ci
s.p.a. -
Th
e d
ata a
n
d i
nf
or
m
ati
on r
ep
orte
d i
n th
is i
n
sta
lla
tio
n m
an
u
al a
re s
u
sc
ep
tib
le to c
h
an
g
e at a
ny ti
m
e a
n
d w
ith
ou
t o
b
lig
ati
on o
n C
A
M
E c
an
ce
lli
auto
m
ati
ci
s.p.a. to n
otify u
se
rs.
ENGLISH
LIST OF CONTROL LED SIGNALS OF THE COMMAND AND SAFETY DEVICES:
- «ALIM» Green LED. Normally on, because it signals the cards proper power rate.
- «PROG» Red LED. Normally off.
During the remote control’s activation procedure, it turns on and blinks.
It blinks faster when combined with LEDs C1/C3/ST
- «C1»
Yellow LED. Normally off.
When it is on and with the PROG LED blinking it warns of objects detected by the photocells (connected to REOPEN
DURING CLOSING) or non-operation of the same.
- «C3»
Yellow LED. Normally off.
When it is on and with the PROG LED blinking it warns of objects detected by the photocells (connected to PARTIAL STOP)
or non-operation of the same.
- «ST»
Yellow LED. Normally off.
When it is on and with the PROG LED blinking it means the TOTAL STOP button has been pushed, or non-operation of the
same.
10 Signal LED
11.2 - RADIOFREQUENCY CARD
Connect the antenna’s RG58 cable to
the apposite terminals.
Possible output of the radio receiver’s
second channel (N.O. socket).
Socket rating: 5 A-24 V DC.
(Also see Chapt. 6.5)
11 Activating the remote control
11.1 - ANTENNA
AF card
Lock the radiofrequency card into the electronic card AFTER CUTTING
OFF THE POWER SUPPLY (or after disconnecting the batteries).
N.B.: the electronic card only recognises the radiofrequency card
when the power is on.
