CAME ZBK8, Руководство пользователя

Страница: 9 / 28

9
ENGLISH
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
Memorizing the code on the command board
- Connect the antenna with the RG58 cable to the apposite terminals on the board .
- The AF1 board must ALWAYS be inserted into the coupling when the power is off because the motherboard only recognises it when it
is powered.
- Keep the " CH1 " key pressed on the base card, the signal LED will fl ash.
- Press a transmitter key to send the code; the LED will remain lighted to signal memorization.
N.B.: if the code needs to be changed, repeat the sequence described above.
- Disconnect the 230V power and insert the AF2 radio card (with the same frequency used for AF1 card) in the slot , the motherboard
recognises it only when it is battery powered.
- Insert the terminal (-, +) connected to the battery to the free coupling of the motherboard .
Note: the board must be battery-powered for saving procedures. Check the LED signalling 230V power is off.
- Keep the key on the basic board depressed. The signalling LED fl ashes (intermittent LED).
- Press a key (the same one memorized for opening the gate) on the transmitter to send the code. The LED will remain lighted to signal
successful memorization.
N.B.: if the code needs to be changed, repeat the sequence described above.
Installation procedure for the remote control for automatically releasing the motor (pratico system)
c
d
e
e
f
g
h
i
j
j
9
ENGLISH
The data and information provided in this manual are to be considered susceptible to change at any time without warning, by CAME cancelli automatici s.p.a.
Memorizing the code on the command board
- Connect the antenna with the RG58 cable to the apposite terminals on the board .
- The AF1 board must ALWAYS be inserted into the coupling when the power is off because the motherboard only recognises it when it
is powered.
- Keep the " CH1 " key pressed on the base card, the signal LED will fl ash.
- Press a transmitter key to send the code; the LED will remain lighted to signal memorization.
N.B.: if the code needs to be changed, repeat the sequence described above.
- Disconnect the 230V power and insert the AF2 radio card (with the same frequency used for AF1 card) in the slot , the motherboard
recognises it only when it is battery powered.
- Insert the terminal (-, +) connected to the battery to the free coupling of the motherboard .
Note: the board must be battery-powered for saving procedures. Check the LED signalling 230V power is off.
- Keep the key on the basic board depressed. The signalling LED fl ashes (intermittent LED).
- Press a key (the same one memorized for opening the gate) on the transmitter to send the code. The LED will remain lighted to signal
successful memorization.
N.B.: if the code needs to be changed, repeat the sequence described above.
Installation procedure for the remote control for automatically releasing the motor (pratico system)
c
d
e
e
f
g
h
i
j
j