SERIE
RODEO
12
Mounting screw
MECHANICAL ADJUSTMENTS
Mounting screw
ADJUSTING THE BELT TENSION
If necessary, the idle pulley
can be used to adjust the
tension on the belt. Proceed
as follows:
1) Loosen the mounting
screws on the pulley.
2)Rotate the adjustment
screw until the correct belt
tension is obtained.
3)Tighten the mounting
screws carefully to maintain
the correct tension.
Pulley clamping crews
Screw for adjusting belt tension
ANTI-VIBRATION BRACKET ON THE PROFILE HOUSING
This bracket prevents the (optional) profile housing from
oscillating and bending longitudinally. One bracket can be
installed when the beam is mounted at a height of up to 2.80
m, while both brackets should be installed if beam height
exceeds 2.80 m. If necessary, the bracket may be bent into
the required shape.
ADJUSTING THE MECHANICAL STOPS
The mechanical stops are used to set and adjust the
opening width of the door wings so that they do not move
beyond the ends of their travel.
Loosen the mounting screws and move these stops to
the proper positions.
N.B.: The mechanical stops must be correctly placed
and tightened to prevent damage to the guide track and
permit its adjustment.
PLACEMENT OF
MECHANICAL STOPS
AND
ANTI
-VIBRATION BRACKETS
