Pa
g.
1
4
14
- M
an
u
al c
od
e:
11
9
G
3
1
2
0
11
9
G
3
1
2
0
ve
r.
0
.2
0.
2
0
8
/2
0
10 © C
A
M
E c
an
ce
lli auto
m
ati
ci s.p.a. - T
h
e d
ata a
n
d i
nf
or
m
ati
on r
ep
orte
d i
n th
is i
n
sta
lla
tio
n m
an
u
al a
re s
u
sc
ep
tib
le to
c
h
an
g
e at a
ny ti
m
e a
n
d w
ith
ou
t o
b
lig
ati
on o
n C
A
M
E c
an
ce
lli auto
m
ati
ci s.p.a. to n
otify u
se
rs.
ENGLISH
Do not allow children to play or loiter in the operating range of the turnstile.
Keep command and control devices out of reach of children, to prevent the turnstile from being accidentally activated.
Immediately suspend use of the turnstile if any anomalies are manifested.
Danger Hands could be crushedr
Danger voltage running through parts
Transit prohibited during operation.
Important general safety instructions
This product must be only used for its specific intended purpose. Any other use is wrongful and therefore dangerous. The manu-
facturer is not liable for any harm or damage caused by improper, wrongful or unreasonable use.
9 Safety instructions
The periodic maintenance checks are the following:
Check turnstile’s internal cabling, check that cables are not disconnected or damaged.
Use hands to verify secure grounding of turnstile, if not tightly anchored it could be dangerous.
Do not clean the turnstile with chemical products that may damage the stainless steel, do not use abrasive substances
or rags that may scratch the surface.
10.1 Periodic maintenance
DISFUNCTIONS
POSSIBLE CAUSES
CHECK AND REMEDIES
The turnstile release only to-
wards one direction
• Buttons 22-23 or 24-25 are pressed down
• Check connections
The turnstile remains locked
• Active STOP button
• Check validity of release command
10.2 Trouble shooting
10 Maintenance
10.3 Possible reprogramming of the end points
If you need to reprogram the turnstile’s end points (e.g. when setting a diff erent opening angle for the wing), follow the proce-
dure described below:
IMPORTANT: before programming, carefully read all instructions and follow them in the order they are presented otherwi-
se you will not be able to program. Each time the P1 button is pressed, a sound should be emitted confi rming a command has
been received. Wait for this sound signal, before pressing button again.
The programming procedure is fi nished when you hear a triple beep sound.
