CAME BXV Series, Руководство по установке

Страница: 57 / 144

8 8 8
p.
21
- M
an
ua
l
FA
010
04
-E
N
- 0
1/
20
18 - © C
AM
E S
.p
.A
. - T
ra
ns
la
te
d o
rig
in
al i
ns
tru
ct
io
ns
F1 Total stop [1-2]
NC input – Gate stop that excludes any automatic closing; to resume movement, use
the control device. The safety device is inserted into [1-2].
OFF = Deactivated ( default ) / ON = Activated
F2 Input [2-CX]
NC input – Can associate: C1 = reopening during closing by photocells, C2 = reclosing
during opening by photocells, C3 = partial stop, C4 = obstruction wait, C7 = reopening
during closing by sensitive safety-edges, C8 = reclosing during opening by sensitive
safety-edges.
OFF = Deactivated ( default ) / C1 / C2 / C3 / C4 / C7 / C8
F3 Input [2-CY]
NC input – Can associate: C1 = reopening during closing by photocells, C2 = reclosing
during opening by photocells, C3 = partial stop, C4 = obstruction wait, C7 = reopening
during closing by sensitive safety-edges, C8 = reclosing during opening by sensitive
safety-edges.
OFF
= Deactivated (
default
) /
C1
/
C2
/
C3
/
C4
/
C7
/
C8
F5 Safety test
After every opening or closing command, the board will check whether the photocells
are working properly.
 The safety test is always active for wireless devices.
0 = Deactivated ( default ) / 1 =CX / 2 =CY / 4 =CX+CY
F6 Maintained
action
The barrier opens and closes by keeping a button pressed. Opening button on contact
2-3 and closing button on contact 2-4. All other control devices, even radio-based
ones, are excluded.
0
= Deactivated (
default
) /
1
= Activated
F7 Command [2-7]
From the control device connected to 2-7, it performs the (open-close-invert) step-step,
(open-stop-close-stop), sequential, open or close command.
0 = Step-step ( default ) / 1 = Sequential / 2 = Open / 3 = Close
FUNCTIONS MENU

IMPORTANT! Start programming by first performing the following: MOTOR-TYPE SETTING (A1),
OPENING DIRECTION (F54), TOTAL STOP (F1) and TRAVEL CALIBRATION (A3)
⚠
Only program functions when the operator is stopped.

You can memorize up to 25 maximum users.

When the menu is active, the system cannot be used.
Display
The < > keys are for:
- moving from one item to another;
- increasing or decreasing values.
- after a travel calibration they allow an OPEN or CLOSE command
The ESC button is for:
- exiting menus;
- cancelling changes.
- during operation it works
from a STOP command
The ENTER key is for:
- entering menus;
- confirming or memorizing set values.
DESCRIPTION OF PROGRAMMING COMMANDS