CAME 846NC-0140, Руководство по настройке

Страница: 20 / 48

Pa
ge
8
- M
an
ua
l
FA
00
772
-E
N
- v
er
s.
1
- 0
5/
20
17
- © C
am
e S
.p
.A
. - T
he d
at
a a
nd i
nf
or
m
at
io
n s
ho
w
n i
n t
hi
s m
an
ua
l a
re t
o b
e c
on
si
de
re
d s
ub
je
ct t
o c
ha
ng
e a
t a
ny t
im
e a
nd w
ith
ou
t t
he n
ee
d f
or a
ny a
dv
an
ce w
ar
ni
ng
.
[Radio signal]
Shows the radio signal level (from 1 to 6) for each learnt siren. If the siren has not
yet been learnt, the radio signal is 0.
The value is shown on the second line of the display as follows:
WL[#-----] = Level 1 signal (low)
WL[###---] = Level 3 signal (medium)
WL[#####-] = Level 5 signal (high)
Siren
Radio signal
The alarm events occur when the status on one of the configured inputs changes.
[Show alarms] (default: YES)
Enables or disables the alarm view.
The alarm events may be:
- N.C. (Status): the alarm status is reset by the user on the device that generated
the alarm (e.g. magnetic contact);
- CI
(impulse): the alarm status is reset once the time set in the
[SETTINGS]/[T.RE-
STORE] menu has lapsed (e.g. shutter contact, volumetric sensors, etc.) .
To set the alarm events, see the remote device manual.
These events are reset when the alarm stops but remain visible in the [ALARM
MEMORY]
. They are permanently deleted when the ON/OFF channel is next ena-
bled or by entering the user code and pressing one of the buttons.
[Test]
Changes the status on the chosen channel to check it is working correctly.
[Polarity] (default: ON/OFF = 12V - engaged, SIREN = 12V - alarm, OTHER
= normally closed)
Chooses the channel operating status. This choice depends on the operation of the
control unit the receiver is connected to.
Polarity
[Status]
(default: all enabled except the ON/OFF channel)
[ENABLED] the channel signal changes according to the configuration of the as-
sociated devices.
[DISABLED] the channel signal does not change.
Choose which channel to enable:
- OUTPUTS (1 to 8),
- TAMPER, SUPERVISION, BATTERY and JAMMING,
- ON/OFF,
- SIREN
Events
Show alarm memory
Test
Status
Wired IN/OUT