Page 3 of 11
WC13PS SERIES RESTROOM CONTROL
INSTALLATION INSTRUCTIONS
SURFACE MOUNT RESTROOM INSTALLATION
1. Place the white vinyl sign behind the surface aura enclosure
and place them against the mounting wall.
2. Use the #10 x 1'' pan head screws with the green pvc anchors
provided to hold the white vinyl sign and the aura enclosure
against the wall .
Note: White vinyl sign does not come with the
CM-45/4 - 4 1/2" 'Push To Open'.
3. Place all the square rubber pads inside the flush aura enclosure.
Insert the aura board inside the flush aura enclosure, making
sure the screw holes on the aura board align with the screw
holes inside the surface aura enclosure. Use the #6 x 3/8"
self-tapping screws to tighten Aura board in place.
4. Place the Aura insert inside the surface aura enclosure, making
sure the mounting screw holes on the aura insert and the
surface aura enclosure align.
FOR CM-45/454SE1, CM-45/854SE1 & CM-45/4 SWITCHES
a. Use the 6-32 hex head screws to tighten the aura
insert slightly.
b. Fit in the assembled CM-45/4 by locating the screws
with the holes on the backplate.
c. Fit the hex key through the hole on the face plate and
completely tighten the 6-32 screws in place.
FOR CM-2520-4854SE1 COMBO SWITCH
a. Fit the plastic spacer inside the aura insert
b. Place the combo switch Inside the aura insert, making sure
the mounting holes on the aura and on the back plate align
c. Use the 6-32 Phillips screws to tighten in place.
5. Apply the label to the black vinyl as required.
Surface Aura
Enclosure
#10 x 1”
Pan Head Screw
(4 pcs)
#6 x 3/8” Phillips
self-tapping screw
(2 pcs)
5/8” x 5/8” Square Rubber Pad (4 pcs)
6-32 Phillips
screw (2 pcs)
Aura Board
Plastic spacer
(For use only on CM-2520/48)
Aura Dip Switch Settings
1
REM/LOC
RELAY
SPEAKER
2
3
Enable
ON
1
RED
GREEN
BLUE
RED
GREEN
BLUE
2
3
Active Color
ON
1
2
3
Idle Color
ON
= Switch Position
White Vinyl
Label
Aura Insert
