Page 4 of 11
WC13PS SERIES RESTROOM CONTROL
INSTALLATION INSTRUCTIONS
FLUSH MOUNT RESTROOM INSTALLATION
Flush Aura
Enclosure
Black Vinyl
Dry Wall Bracket
8-32 x 1-1/2”
Phillips Screw
(2 pcs)
#6 x 3/8” Phillips
self-tapping screw
(2 pcs)
6-32 Phillips
screw (2 pcs)
Aura Insert
Aura Board
Plastic spacer
(For use only on CM-2520/48)
Label
Aura Dip Switch Settings
1
REM/LOC
RELAY
SPEAKER
2
3
Enable
ON
1
RED
GREEN
BLUE
RED
GREEN
BLUE
2
3
Active Color
ON
1
2
3
Idle Color
ON
= Switch Position
1. Prepare the cut-out for the unit and fit in the dry wall bracket.
2. Slide in the black vinyl behind the flush aura enclosure and fit
them inside the dry wall bracket.
Note: Black vinyl does not come with the CM-45/4 - 4 1/2"
'Push To Open'.
3. Ensure the two mounting holes on the bracket and the Flush
aura enclosure align. Use the 8-32 phillips screws to completely
tighten in place.
4. Place the aura board inside the flush aura enclosure, making
sure the screw holes on the aura board align with the screw
holes inside the Flush aura enclosure. Use the #6 x 3/8"
self-tapping screws to tighten Aura board in place.
5. Place the Aura insert inside the Flush aura enclosure, making
sure the mounting screw holes on the aura insert and the flush
aura enclosure align.
FOR CM-45/455SE1, CM-45/855SE1 & CM-45/4 SWITCHES
a. Use the 6-32 hex head screws to tighten the aura
insert slightly.
b. Fit in the assembled Push plate by locating the screws
with the holes on the backplate.
c. Fit the hex key through the hole on the face plate and
completely tighten the 6-32 screws in place.
FOR CM-2520-4855SE1 COMBO SWITCH
a. Fit the plastic spacer inside the aura insert
b. Place the combo switch Inside the aura insert, making sure
the mounting holes on the aura and on the back plate align.
c. Use the 6-32 Phillips screws to tighten in place
7. Apply the label to the black vinyl as required.
