CAMDEN CV-603, Руководство по установке

Страница: 5 / 20

Page 5 of 20
CV-603 MPROXBLE CONTROLLER / CV-603PS-K1 MPROXBLE CONTROLLER CABINET KIT
INSTALLATION INSTRUCTIONS
Bill of material:
Camden Model# Camden Model#
Item Description Quantity CV-603PS-K1 CV-603
1 Controller 1 CV-603 provided in kit CV-603
2 DC Power Supply 1 60-69B002 - provided in kit PS-13
3 Transformer 1 CX-TRP-4016 provided in kit CX-TRP-4016
4 Door Strike, 12 VDC 2 CX-ED1079 CX-ED1079
5
Door Position Switch, a door latch
monitor switch can be used, add
suffix "L" to CX-ED1079
2 CX-MDA surface or CX-MDH recessed. CX-MDA surface or CX-MDH recessed.
6
Proximity Card Reader, 125 KHz.
Not required if transmitters are
used.
2 CV-7400 CV-7400
7 Request to Exit Device 1
CM-RQE70 PIR sensor or CM-30E Push
button.
CM-RQE70 PIR sensor or CM-30E Push
button.
System Operation:
a) The doors are normally locked and closed. The door position switch confirms when the doors are closed.
b) A user presents a card credential in front of the card reader. The card reader’s red LED indicates it is powered. When the credential is
within 2 inches, the reader will beep, and the controller red LED will pulse on 1 second to confirm the credential data was received. If the
controller red LED blinks twice, the credential is being denied by the controller.
c) If the credential is approved by the controller, the door strike will energize for the pre-set period duration. The door strike will energize
for the full duration of the period until the door is opened and the door position changes state. As soon as the door is opened, the door
strike shall turn off securing the door as soon as it closes.
d) Users exiting the door, must be detected by the request to exit device; manually by a push switch or automatically using a PIR detector.
Opening the door without a request to exit switch shall cause the controller to generate a door forced open alarm.
e) Administrators shall use the app to control and configure the CV-603 controller using wireless Bluetooth. A steady on blue LED on the
controller will confirm the connection.