Camco VORTEX 3 QUADRO, Руководство пользователя

Страница: 26 / 42

5 OPTIONS
ENTER-Switch
CAI LED
USER MANUAL
VORTEX 3 QUADRO
P.24
USER MANUAL
VORTEX 3 QUADRO
P.25
5.1 CAI (CAMCO Audio Interface)
CAI is a bus system, in which all significant device functions can be monitored
externally and remotely controlled using a master PC. Up to 99 devices can be
controlled in parallel in each phase of the bus system, which simply consists of
a two-core insulated cable. The master can serve several phases for larger appli-
cations. For more information, please contact your dealer or distributor.
CAI allows:
To control the output-level of each Channel independently
(exception: mono modes, only Channel A(C) is affected)
To mute each channel independently
(exception: mono modes, only Channel A(C) is affected)
To switch the VORTEX into STANDBY (and back again)
To monitor temperature, output-signal, clip, output-current.
5.1.1 Wiring
To connect the VORTEX to your CAI system use a fully-wired telephone-type
cable with RJ12 connectors. For longer distances use high grade cable like
for RS485, DMX512 for AES/EBU digital audio. You can chain several
VORTEX
amplifiers using the second CAI connector on each amplifier. A linear network
topology is recommended with 100 Ohm termination at its end. Please refer to
RS485 specifications.
5.1.2 CAI Address Settings
The VORTEX 3 QUADRO uses two addresses to communicate with the master
PC. You only select the address for amplifier A/B, the address of amplifier C/D is
automatically set to address for amplifier A/B plus one.
The CAI address selection procedure will not affect the operation of the
VORTEX but whilst this procedure is active, the volume cannot be adjusted by
using the pots.
NOTE: Ensure you return both pots to their original position after address
selection is complete, otherwise the amplifier will change its volume level
to the new pot positions!
Briefly press the ENTER-Switch . This push button switch can be accessed
through the 3 mm hole in the front panel located between the On/Off switch
and the LEDs.
Example of LED sequences for different address settings:
Adresses (A/B)/(C/D) On-LED Channel A => Tens On-LED Channel B => Units
01/02 (factory settings) 0* flash 1* flash then short pause
25/26 2* flashes then short pause 5* flashes then short pause
After briefly pressing the Enter-Switch the actual address of amplifier A/B will be
displayed by the On LEDs of ChA and ChB. The address of amplifier C/D is not shown.
Flashing of On LED channel A indicates the tens
Flashing of On LED channel B indicates the units of the address of amplifier A/B