Cambridge Sensors MicroDot Xtra, Операции

Страница: 24 / 31

MATERIAL SAFETY DATA SHEET
Section V - Fire Fighting Measures
Section VI - Accidental Release Measures
Section VII - Handling and Storage
Storage Temperature
Handling/Storage
Ventilation Requirements
Sensitivity to Static Electricity
Sensitivity to Mechanical Impact
Store vials as directed in the package insert.
Handle and store vials as directed by the package insert.
No special requirements.
Not known
Not known
Not required under normal use of this product.
Not required under normal use of this product.
Wear appropriate gloves to prevent skin contact. Replace
torn or punctured gloves promptly.
Wear appropriate eye protection to prevent eye contact.
Wear appropriate body protection to prevent skin contact.
Eye wash stations and deluge showers.
Good laboratory technique should be used when handling
this product. Observe appropriate chemical hygiene.
Do not place in mouth.
Do not eat, drink or smoke while working with this product.
Upon completion of work activities involving this product,
wash hands thoroughly with soap and water.
Respiratory Protection
Ventilation
Protective Gloves
Other Protective Equipment
Other Engineering Controls
Work Practices
Hygienic Practices
Not determined
Not determined
Use fire extinguishing media appropriate for site collections.
Structural fire fighting gear and self-contained breathing
apparatus will provide adequate protection if this product
is in a fire area.
Not determined
Thermal decomposition may emit carbon monoxide and
carbon dioxide.
Not determined
Not determined
Use an absorbent material to contain/pick up the spilled
solution. Place all contaminated disposals into a suitable
container, seal, label and hold for disposal.
Spill and Leak Procedures
Section VIII - Exposure Controls / Personal Protection
Auto-flammability
Flash Point (test method)
Extinguishing Media
Special Fire Fighting
Procedures
Fire and Explosion Hazards
Hazardous Combustion
Products
Upper Explosion Limit (%)
Lower Explosion Limit (%)
Chapter 8
22
Cambridge Sensors USA, LLC
Microdot® Control Solutions
INITIAL SETUP OF THE METER
Before using the Microdot Xtra Meter for the first time, you should set the actual Time,
Date and Year. The unit of measurement is preset and can not be changed.
Setting the Time, Date and Year
Enter the Set Mode.
To Enter the set mode, turn the meter on by
pressing the C button. After the segment test,
the time and date will start to flash.
Step 1
Set the Time and Date Format.
Pressing the C button again will now toggle
between US and International Time
and Date formats.
For US: 12h Time format, mm-dd (begins with
AM setting). To accept the desired setting,
press the M button.
Step 2
Set the Hour.
The Hour will start to flash. It can now be
changed by pressing the C button. The US
setting will begin at 12:01 AM and will move
to PM. To accept the correct setting, press
the M button.
Step 3
Set the Minutes.
The Minute will start to flash, it can now be
changed by pressing the C button. To accept
the correct setting, press the M button.
Repeat Steps 1 & 2 to set Month and Year.
1.
2.
3.
Chapter 2
5
Cambridge Sensors USA, LLC
®
Xtra