Cambridge Elevating JOURNEY LU, Руководство по установке

Страница: 16 / 40

Hydraulic Cylinder Installation
NOTE : Installing the cylinder before the sling will make things easier, however the sling might
be in the way when you want to run your hard pipe. Do what is ideal for your situation.
Procedure:
1. Lower cylinder into shaft with piston end up and place bottom end onto the top of the jack-
post
2. Loosely clamp cylinder to cylinder bracket with the provided U bolt
3. Rotate to access cover plate, located at bottom of cylinder
4. Attach line rupture valve with O rings properly seated ( see image below )
5. Run your hydraulic lines as per code requirements for your State or Province
6. Rotate line rupture valve towards the rail wall
7. Tighten clamp holding cylinder to bracket
8. Remove shipping bracket from top of cylinder
9. Install plastic drain elbow and drain line
10. If site conditions permit, the clear pvc drain line should be run from the cylinder head to the
pump. Ensure route of hose allows for fluid to run freely back to the pump. If hose is not
long enough, run to an appropriate drain-container ( not provided ) within the pit
11. Complete installing hydraulic lines between cylinder and the pump. (Use fittings provided)
NOTE: Refer to hoistway drawings to ensure there is sufficient clearance along the chosen
route.
12. Fill the pump reservoir with 32 or 46 weight type hydraulic oil