Cambium Networks PMP 450 AP, Руководство по настройке

Страница: 367 / 649

Chapter 2: Tools Using the Link Capacity Test tool
Page
2-339
Link Test with Multiple LUIDs
Note
The “Link Test with Multiple LUIDs” Link Capacity Test is supported for PMP 450m
Series AP only.
Figure 73 Link Capacity Test – PMP 450m Series AP
Procedure 24 Performing a Link Capacity Test - Link Test with Multiple LUIDs
Link Test Configurations parameters
1 Access the Link Capacity Test tab in the Tools web page of the module.
2 Set Link with Multiple Data Channels attribute to Link Test Low Priority Data Channels,
Link Test Low and Medium Priority Data Channels, Link Test Low, Medium and High
Priority Data Channels, or Link Test All Data Channels.
3 Set the MU-MIMO attribute to Enabled or Disabled.
Note: The MU-MIMO feature is enabled on the Low Priority Data Channel only
4 Set the Ignore Configured CIR attribute to Enabled or Disabled.
5 Set the User Traffic During Link Test attribute to Block User Traffic or Allow User
Traffic.
Link Test Settings parameters
6 Enter LUID List (applicable for PMP 450m AP only)
The Current Subscriber Module and LUID List are valid only when selecting Link Test with
Multiple LUIDs.
• Current Subscriber Module: select the LUID to perform the link test with
• LUID list: select a list or range of LUIDs to include in the link test with multiple LUIDs
If left blank, all LUIDs will be included in the link test
7 Type into the Duration field how long (in seconds) the RF link must be tested.
8 Select the Direction attribute to Bi-directional, Uplink Only, or Downlink Only.
9 Type into the Number of Packets field a value of 0 to flood the link for the duration of the
test.
10 Type into the Packet Length field a value of 1714 to send 1714-byte packets during the
test.