Cambium Networks PMP 450 AP, Руководство по настройке

Страница: 251 / 649

Chapter 1: Configuration Setting up SNMP agent
Page
1-223
SNMP Community
String 2 (Read Only) Specify an additional control string that can allow a Network Management
Station (NMS) to read SNMP information. No spaces are allowed in this
string. The default string is Canopyro. This password will never authenticate
a user or an NMS to read/write access.
The Community String value is clear text and is readable by a packet
monitor. Additional security derives from the configuration of the Accessing
Subnet, Trap Address, and Permission parameters.
Engine ID The Engine ID may be between 5 and 32 hex characters. The hex character
input is driven by RFC 3411 recommendations on the Engine ID. The default
Engine ID is the MAC address of the device
SNMPv3 Security
Level Specify security model where users are defined and authenticated before
granting access to any SNMP service. Each device can configure the security
level of SNMPv3 to No authentication/No privacy, Authentication/No
privacy, or Authentication/Privacy.
SNMPv3
Authentication
Protocol Currently, the SNMPv3 authentication protocol MD5 is supported.
SNMPv3 Privacy
Protocol Currently, the SNMPv3 privacy protocol CBC-DES is supported.
SNMPv3 Read-Only
User This field allows for a read-only user per devices. The default values for the
Read-Only users is:
• Username = Canopyro
• Authentication Password = authCanopyro
• Privacy Password = privacyCanopyro
SNMPv3 Read/Write
User Read-write user by default is disabled. The default values for the Read/Write
users is:
• Username = Canopy
•
Authentication Password = authCanopy
• Privacy Password = privacyCanopy
Additional SNMP v3
User 1 This field allows to configure the Additional SNMP v3 User 1. The
configurations include:
• Enable/Disable User: These fields allow to enable or disable the user
using the Enable User or Disable User radio buttons.
• Authorizaton Key: This field allows to configure an authorization key for
the user.
• Privacy Key: This field allows to configure a privacy key for the user.
Note
Set SNMP v3 Security Level field to: auth, priv to enable the
Authorization Key and Privacy Key fields.