Cambium Networks ePMP, Руководство пользователя

Страница: 132 / 478

CAMBIUM NETWORKS
026v003
132
Attribute Meaning
i. If the AP with CMM3 sync source has Frequency-
Reuse-Back ON, then the other AP (with “onboard
GPS” or CMM4 sync source) must have the
Frequency-Reuse-Back ON.
ii. If the AP with CMM3 sync source has Frequency
Reuse Mode set to Off, then the other AP (with
“onboard GPS” or CMM4 sync source) must have
Frequency Reuse Mode set to Off.
Alternate
Frequency Carrier
1 Channel
Bandwidth Configure the first channel bandwidth configuration that will be used for
RF transmission if DFS detection causes the radio to switch from using the
channel bandwidth configured in Channel Bandwidth.
Alternate
Frequency Carrier
1 Configure the first frequency that will be used for RF transmission if DFS
detection causes the radio to switch from using the frequency configured
in Frequency Carrier. It is important to set this frequency also in the SM
Scan List.
Alternate
Frequency Carrier
2 Channel
Bandwidth Configure the second channel bandwidth configuration that will be used
for RF transmission if DFS detection causes the radio to switch from using
the channel bandwidth configured in Channel Bandwidth.
Alternate
Frequency Carrier
2 Configure the second frequency that is used for RF transmission if DFS
detection causes the radio to switch from using the frequencies configured
in Frequency Carrier and DFS Alternate Frequency Carrier 1. It is important
to set this frequency also in the SM Scan List.
Power Control
Transmitter
Output Power This value represents the combined power of the AP’s two transmitters.
This value may be automatically adjusted based on the configuration of the
parameter Country.
Nations and regions may regulate transmitter output power. For example

2.4 GHz and 5 GHz modules are available as connectorized radios,
which require the operator to adjust power to ensure regulatory
compliance.
The professional installer of the equipment has the responsibility to
 maintain awareness of applicable regulations.

calculate the permissible transmitter output power for the module.

confirm that the initial power setting is compliant with national or
regional regulations

confirm that the power setting is compliant following any reset of the
module to factory defaults.