CAMBIUM NETWORKS
026v003
128
Attribute
Meaning
Disabled – ACS is disabled and the operator should configure a Frequency
Carrier manually.
Note
The channel bandwidth configured prior to enabling and running ACS will
be used to automatically select a channel. For ex: If the operator manually
configured a channel bandwidth of 20MHz, ACS will scan and choose a
channel of 20MHz wide channel. To switch ACS to 40MHz or other channel
bandwidth, the operator should disable ACS, manually configure 40MHz or
desired channel bandwidth on the radio, then enable and run ACS.
Channel
Bandwidth
Configure the channel size used by the radio for RF transmission. This value
must match between the AP and SMs.
Frequency Carrier Configure the frequency carrier for RF transmission. This list is dynamically
adjusted to the regional restrictions based on the setting of the Country
Code parameter.
Frequency Reuse
The Frequency Reuse Mode parameter allows operators to define which
APs are co-located (or within radio range) with other APs. This definition
results in an automatic radio network modification such that self-
interference is reduced amongst the co-located sectors.
A network in which two frequencies “F1” and “F2” are reused throughout
the deployment in shown in
Figure 35 Frequency reuse deployment
F1
F1
F2
F2
F1
F1
F2
F2
F1
F1
F2
F2
F1
F1
F2
F2
F1
F1
F2
F2
The set of APs to configure the Frequency Reuse Mode option on is
dependent on the GPS synchronization sources in the whole network,
CMM3, CMM4 or “onboard GPS” (GUI options are: GPS or CMM).
Содержание ePMP
