Calspas Rejuvenation Series, Руководство пользователя

Страница: 15 / 40

Rejuvenation Series Spas
LTR50001131, Rev. A
Operating
Your Spa
www.calspas.com
13
Adjusting Filtration
Main Filtration
Filter cycles are set using a duration. Each setting can be adjusted in 1-hour increments. Filter Cycle 1 and
Filter Cycle 2 (if enabled) are set to the same duration.
If Filter Cycle 2 is enabled, Filter 12 will appear in the LCD. If Filter is disabled, Filter 1 will appear.
Press the WARM button. The temperature display will flash. 1.
Press the LIGHT button six times and the display will read FLTR. 2.
Set the filter cycle as follows: 3.
Setting Preferences
This allows you to set the following preferences for system operation:
Change the temperature between Fahrenheit and Celsius •
Change the clock between 12-hour and 24-hour display •
Turn periodic reminders (like “CLEAN FILTER”) on or off •
Press the WARM button. The temperature display will flash. 1.
Press the LIGHT button six times and the display will read PREF. 2.
To toggle through the preferences, press the WARM button. 3.
Press: Once
Then
Press:
7X
Press: Once
Then
Press:
8X
Utilities
This menu feature is for system information only and is used mainly for repair and troubleshooting.
Sets Filter 1 length in hours
Sets start hour Selects minutes
Selects part of an hour
SET FLTR1 P SET FLTR1 P SET FLTR1 P
Sets 15-minute increments
SET FLTR1 P
FLTR1 FLTR1 SET FLTR1 SET FLTR1 SET FLTR1
Shows/flashes start time
FLTR1
to show RUN HRS
to show F1 ENDS xx:xx
Sets 15-minute increments
A
1
Main Screen
READY RANGE FLTR1
To next item in
Main Menu
To Set
To Set
Waiting
Several Seconds
Reverts to Original Setting
Wait to
Revert
Waiting several seconds
will lose any new Filter 1
Start Time and Run Hours and
revert to the previous Filter 1 settings. Key
A temperature button, used for “Action”
Light or dedicated “Choose” button, depending on control panel configuration