Rejuvenation Series Spas
LTR50001131, Rev. A
Operating
Your Spa
www.calspas.com
11
Press the WARM button. The temperature display will flash.
1.
Press the WARM or COOL buttons to adjust the set temperature.
2.
When the temperature stops flashing, the spa will heat to the new set temperature
when required. The temperature can be set between 60°F and 104°F.
Adjusting the Set Temperature
Setting the Heat Mode
Press the WARM button. The temperature display will flash.
1.
Press the LIGHT button twice and the display will read MODE.
2.
Press WARM or COOL to select the heat mode.
3.
There are two heat modes: READY Mode and REST Mode.
READY Mode: In order for the spa to heat, a pump needs to circulate water through the heater. The pump
that performs this function is known as the “heater pump.”
The heater pump can be either a 2-Speed Pump 1 or a circulation pump. If the heater
pump is a 2-Speed Pump 1, READY Mode will circulate water every 1/2 hour, using Pump 1
Low, in order to maintain a constant water temperature, heat as needed, and refresh the
temperature display. This is known as “polling.”
REST Mode:
REST Mode will only allow heating during programmed filter cycles. Since polling does not
occur, the temperature display may not show a current temperature until the heater pump
has been running for a minute or two.
Circulation Mode
If the spa is configured for 24-hour circulation, the heater pump generally runs continuously. Since the heater
pump is always running, the spa will maintain set temperature and heat as needed in Ready Mode, without
polling.
In Rest Mode, the spa will only heat to set temperature during programmed filter times, even though the
water is being filtered constantly when in Circulation Mode.
Ready-in-Rest Mode
READY/REST appears in the display if the spa is in Rest Mode and Jet 1 is pressed. It is assumed that the spa
is being used and will heat to set temperature. While Pump 1 High can be turned on and off, Pump 1 Low will
run until set temperature is reached, or 1 hour has passed. After 1 hour, the System will revert to Rest Mode.
This mode can also be reset by entering the Mode Menu and changing the Mode.
Press the WARM button. The temperature display will flash.
1.
Press the LIGHT button three times and the display will read TIME.
2.
Press the WARM and COOL buttons to change the hour. Press the LIGHT
3.
button to adjust minutes.
Setting the time of day is important for determining filtration times and other
background features. 24-hour time display can be set under the PREF menu.
Setting Time
Press:
Once
Then
Press:
Twice
Press:
Once
Then
Press:
3X
Press:
Once
Then
Press:
Once
Содержание Rejuvenation Series
Страница 1: ...LTR50001131 Rev A 1 2 13...
