19 |
P a g e
REMOTE ALARM MODULE:
Allows for a signal to be connected to a
remote monitor such as a buzzer, light, alarm system, PLC, etc., via a pair
of contacts. In normal operation the OK and COM contacts will be
connected, and in a fault condition (Low UV, Lamp fail, Power Fail), the
Fault and COM contacts will be connected. Maximum Contact Rating is 1A-‐
120VAC/VDC (uses 16-‐22 AWG).
SOLENOID CONNECTION MODULE:
Allows the integration of a
NORMALLY CLOSED line voltage solenoid valve. Simply affix the module's
supplied bare lead cord to the solenoid valve, connect the power cable to
the electrical outlet, and the male IEP connector to the female IEP port on
the controller. PLEASE NOTE: When this device is connected to a CalUltra
system (without the UV module), then the solenoid will close on a lamp
failure mode only. When used on different CalUltra systems, the solenoid
will close when the UV level drops below 50%. Also note that in cases
where emergency use of untreated water is required, the controller can be
placed into a manual override mode allowing for the flow of water in an
alarm condition.
4-‐20 mA MODULE:
Allows for a 4-‐20mA signal transfer of the UV
output to a remote device such as a data logger or computer. Simply plug
the supplied cable into any female IEP connections. Two screw terminals
are supplied to connect the wire that leads to the receiving end of the
signal. As the distance required is unknown, no wire is supplied with this
system, however 16-‐22 AWG is required.
ETHERNET MODULE:
Allows for all controller functions to be
connected to a computer via an Ethernet cable. This module is currently in
development and is not available at this point-‐in-‐time.
Warranty Registration
It is imperative that you complete the warranty registration process. This not only registers your UV disinfection
system for the provided CALMAG YORKSHIRE LTD warranty, but also allows Calmag Yorkshire Ltd to provide you
with any important product updates or technical bulletins concerning your product. The registration process is a
simple process and can be done online at
http://www.calmagltd.com
or by filling out the enclosed warranty card.
Please ensure that ALL information is completed, including a valid e-‐mail address. PLEASE NOTE: This information
is for the sole purpose of technical support for your disinfection system and will not be used, or sold, to any other
organisation for any other purpose.
