1142 Radio Portable Manual - O&M Manual V6
Z:\AA MANUALS & INSTRUCTIONS 2017\1142 Radio System\1142 Radio Portable Manual - O&M Manual V6.docx
Page
19
of
20
Pairing remote radio products to the 1123 over door lamp
When the panic buttons are dispatched with the 1123 Over Door Lamp system they are already
“paired” to that Over Door Lamp.
The 1123 can store in its memory up to five remote units such as radio pendants, portable panic
button, ceiling mounted pull switches and radio wall units.
Pairing
Before adding additional units, ensure that you have all the devices that are to be paired within
reach.
Remove the red lens on 1123 Over Door Lamp by holding the lens top & bottom and squeezing
and lifting it out. This exposes two mini buttons in the round apertures near the top. To enter
setup mode
press both buttons at the same time, the bottom right hand lamp will be lit.
Please note: The pairing mode times out after five minutes.
To add a device, press and hold the right hand button, at the same time press any button on
the pendant or activate any other device that needs to be paired to this unit; the bottom left
hand red lamp will flash twice to confirm the pairing and a beep will sound if a buzzer is fitted.
If the device is already stored in the memory the top two red lamps will flash alternatively. No
further action is required, unless more panic buttons need to be stored, then exit the setup or
allow it to time out.
If there are five panic buttons already stored then the two left hand lamps will be lit until exiting
the setup.
To clear stored devices
If the 1123 memory is full (there are already five paired units in the memory) the two right hand
red lamps will be permanently lit when in setup mode. When more units need to be paired to
replace some of those already paired, the memory needs to be cleared. ALL the units to be
paired to this unit will need to be installed/reinstalled. When entering more devices and the
memory becomes full the two right hand red lamps will again be permanently lit.
To clear the stored devices press the left hand button for 1 second until the bottom left hand
red lamp flashes fast to confirm clearance, the memory full left hand red lamps switch off.
Exiting the setup mode
