1142 Radio Portable Manual - O&M Manual V6
Z:\AA MANUALS & INSTRUCTIONS 2017\1142 Radio System\1142 Radio Portable Manual - O&M Manual V6.docx
Page
11
of
20
Setup Overview
•
To operate the setup menu, the switches at the rear of the unit are used. This mode
cannot be accessed when any alarm calls are active.
•
To gain access to the menu, press both the ‘UP’ and ‘DOWN’ switches at the same time.
•
In this mode, features that dictate the operation of the system can be changed.
•
To advance through the menu levels, press the ‘MUTE’ button on the front of the unit. Th
e
various modes will be listed on the display.
•
To change values inside the level, press the ‘UP’ or ‘DOWN’ buttons.
•
If no buttons are pressed within 10 seconds of the last button press, the program will
revert to SYSTEM CLEAR.
System ID
•
The system ID option is used to isolate systems that are within close proximity of other
1142RX units or when they share a common RS485 loop. At manufacturing, the default
setting is ‘01’ unless previously requested before dispatch.
Display No (Display ID)
•
This ID is used to give the display panel a unique ID. This is set by Call Aid UK at
manufacture and should not be changed
.
Cancel via Source/Panel (Cancel Method)
•
Selecting Cancel
: Calls can be set to be cancelled at the unit from which the Call alert
was sent (SOURCE). (Please refer to specific unit instruction)
•
Calls can be set to be cancelled at the 1142RX (PANEL). This can be done by pressing
the ‘CANCEL’ switch on the 1142RX.
•
If Panel is selected, please skip the next step (Night Mode) as this does not apply to
systems with cancel at the panel
.
Night M Global/Local (Night Mode control)
•
Night Mode is used to adjust the sound level of the 1142RX system. This mode cuts down
the length of beep tone and changes the frequency of the beeps.
•
To activate this mode, press the ‘NIGHT MODE’ switch.
•
While Night Mode is active, the red lamp inside the ‘NIGHT MODE’ switch will be
illuminated.
•
To turn off Night Mode, press the ‘NIGHT MODE’ switch. The lamp should now be turne
d
off.
•
Global mode will allow other display panels on the same system to also control the night
and mute modes on other panels.
•
Local mode will restrict control such as mute and night functions to the individual display
panels. (Not affecting other display panels)
PPB Mode (PPB Display Method)
•
If PPB units are used with this system, the 1142RX can display the ID of the PPB or the
closest location where the PPB was triggered.
•
To have the 1142RX display the PPB ID, select the ‘Fixed’ option.
•
To have the 114
2RX display the PPB location, select ‘Locate’
.
