Calix GigaSpire BLAST u12, Руководство по установке

Страница: 27 / 38

27
Proprietary Information: Not for use or disclosure except by written agreement with Calix.
.
Powering the GigaSpire BLAST - No UPS
The information below describes the powering of any GigaSpire BLAST that does not
include a UPS.
To power up the GigaSpire
1.
Locate the 12 VDC Power Adapter.
2.
Attach one end (2-pin barrel connector) to the rear of the GigaSpire.
3.
Plug the other end into any available 110/220 VAC wall outlet.
4.
The GigaSpire begins its start-up sequence.
GigaSpire BLAST Power Connection
Power In (2-Pin Barrel)
7886
(Optional) Mounting the UPS
Prior to putting the GigaSpire into service, the UPS must be mounted to ensure the low
voltage power cord that is connected between the UPS and the GigaSpire is long enough to
span the distance between the two devices.
Depending on your configuration, power cords of varying lengths may be included:

The AC power cord that runs from the UPS to the AC wall outlet is 8-feet long. Make
sure an AC outlet is available within that distance.

The power/signal cord that runs from the UPS to the GigaSpire is available in any of the
following configurations based on model.