11
Einbau des Batterietrennschalters und
Anschluss der Batterie
Den Batterietrennschalter an geeigneter Stelle (Nähe Batterie)
in die Plusleitung zwischen Batterie und Steuerung einbauen.
– Für den Einbau ist ein Loch mit Ø 25 mm erforderlich.
– Schlüssel gegen den Uhrzeigersinn bis zur Endstellung
drehen und herausnehmen.
– Batterietrennschalter durch das Loch stecken und je nach
Untergrund mit geeigneten Schrauben sicher befestigen.
– Plusleitung der Batterie auftrennen und Kabelschuhe (nicht
im Set enthalten) auf beide Enden des aufgetrennten Kabels
aufcrimpen.
– Den Schlüssel wieder einstecken und auf „OFF“ stellen.
Die Kabel mit den Kabelschuhen am Batterietrennschalter
anschrauben. Anschlussreihenfolge: Kabelschuh, Federring,
Mutter.
Nehmen Sie die weitere Montage gemäß der, jeweils
den Geräten beigelegten, Einbauanweisungen vor.
+ Batterie
ON
Schlüssel
entnehmen /
stecken
OFF
+ Steuerung
Ø 25 mm
Mover
Bild 4: Einbau des Batterietrennschalters
– +
Batterietrennschalter
Steuerung
Mover
Batterie
Bild 5: Anschluss der Batterie