5
Anschlüsse
2
3 4
5
6 7
1
Battery
Battery
Sense Battery
B+
Ready
Lead-acid
Gel
Te
mp.- sensor
from Battery
Bild 1: Anschlüsse
1 Kaltgerätesteckeranschluss 230 V ~
2 Umschalter Gel- bzw. AGM / Flüssigelektrolytbatterie
3 Anschluss für Temperaturfühler
4 Funktionsanzeige
5 Eingang B+ Messleitung von Batterie
6 A Ladeleitung Batterie
7 Ausgang - Ladeleitung Batterie
Ladevorgang
Der Ladeautomat besitzt einen elektronischen Verpolungs-
schutz. Nur wenn die Batterie richtig angeschlossen ist und
eine Mindestspannung von 1,5 V anliegt, wird der Ladestrom
freigegeben. Während des Ladevorgangs wird die Batterie-
spannung ständig über die B+ Messleitung überwacht. Der
Ladevorgang erfolgt gemäß der Ladekennlinie unter gerings-
ter Verlustleistung. (Ladekennlinie siehe Bild 2).
Hauptladephase
(alle Spannungswerte bezogen auf 20 °C Batterietemperatur)
Ladung mit maximalem konstanten Ladestrom bis annähernd
14,4 V Batteriespannung erreicht sind. Sinkt in diesem Bereich
der Hauptladephase der Ladestrom bedingt durch den Batte-
rieinnenwiderstand und Leitungswiderstände unter 90 % des
Nennstromes ab, wird die Nachladephase gestartet.
Nachladephase
(alle Spannungswerte bezogen auf 20 °C Batterietemperatur)
Die Ladespannung wird über eine Zeitdauer von zehn Stunden
bei Gelbatterien / AGM bzw. vier Stunden bei Flüssigelektro-
lytbatterien konstant auf 14,4 V gehalten. Nach Ablauf dieser
Zeit erfolgt eine Umschaltung in die Erhaltungsladephase.
Steigt während dieser Zeit der Strom auf über 90 % des
Nennstromes und sinkt dabei die Batteriespannung für einen
Zeitraum von mehr als 15 Minuten bei Flüssigelektrolytbat-
terien und mehr als zwei Stunden bei Gel- und AGM-Batte-
rien unter 13,2 V, so erfolgt eine Umschaltung zurück in die
Hauptladephase.