6
REMOVING THE CLEANER FROM THE POOL
GENERAL MAINTENANCE
• Slowly pull the floating cord to get the cleaner to the pool surface and near
the edge of the pool. DO NOT PULL THE CLEANER OUT OF THE POOL BY
THE CORD OR THE SWIVEL.
• Reach down and grasp the handle of the cleaner and remove it from the
pool as shown in Figures 1 and 2 .
Please follow the below procedures to ensure maximum cleaner performance and overall
component condition.
Water Chemistry
The following ranges are the recommended water levels to maintain a
properly balanced pool.
PH Level: 7.2 – 7.8
Total Alkalinity: 80 – 150ppm
Calcium Hardness: 150 – 300ppm
NOTE: Properly balanced water is a guideline for preserving warranty coverage.
FIGURE 1: Grasping Handle
FIGURE 2: Lift from Pool by Handle
CLEANING THE FILTER BAG (Filter Bag Should Be Cleaned After Every Use.)
• Turn cleaner upside down and place on ground so the bottom lid is exposed.
• Press the red tabs inward towards the center of the cleaner as shown in figure 3.
Lift the bottom lid with the filter bag up and out of the cleaner.
FIGURE 3
• Grasp the bottom lid firmly, with one hand and use your other hand to grab the filter bag
material and pull it away and up from the bottom lid (see Figure 4).
FIGURE 4
• Turn filter bag inside out and hose off all debris as shown in Figure 5. If very dirty it may
be washed in your washing machine, inside out, with cold water, mild detergent, and by
itself. Do NOT put in the dryer.
FIGURE 5
• Hose all debris off the bottom lid being sure to get all dirt out of the fine filters on the
intake doors as shown in Figure 6.
FIGURE 6
