4
FIGURE E1
FIGURE S6A
HOLD
FIGURE S6B
FIGURE E3
FIGURE E2
6)
Confirm that the all connections to the swivel are tightened properly prior to placing
the cleaner into the pool.
Installing an Extension Cord
NOTE:
This section is only necessary for pools with depths greater than 8’.
NOTE:
Ensure the gasket inside the swivel is still secured in place after the plug is removed
from the swivel.
IMPORTANT:
DO NOT use any tools for the following steps. All connections should be
hand tightened.
IMPORTANT:
Check all connections are firmly in place prior to using the cleaner. The
cleaner is now ready to use as per the normal operation instructions.
1)
Remove the entire cleaner from the pool.
2)
Dry all connections and the Floating Swivel.
3)
Disconnect the short cable from the swivel by loosening the black collar and gently
pulling on the plug (Figure E1).
5)
Secure the connection by rotating the black collar in a clockwise direction until it is
hand tight.
6)
Insert the Extension Cord Union on the end of the Extension Cord and secure it by
hand tightening the black collar on the end of the cable (Figure E3).
NOTE:
The Extension Cord Union has two distinctly different sockets to prevent an incorrect
connection.
7)
Insert the blue plug on the 8’ cable into the other end of the union and hand tighten
the black collar, ensuring the gasket is in place prior to making the connection
(Figure E3).
4)
Insert the blue plug of the Extension Cord into the open end of the swivel ensuring
that the gasket is firmly in place prior to making the connection (Figure E2).
EXTENSION
CORD
EXTENSION CORD
EXTENSION CORD UNION
8’CABLE
HOLD
