EN - 15
Mounting bolt
rubber cushion.
1
2
3
Remove the
two screws.
Installation Guide
Installation Procedures
First complete the electrical connections, and
check for correctness.
— — — — — — — — — — — — — — — — — — — —
Reset
Press
button to flip down the panel. Then
press the RESET button with a pointed object
to reset the unit to the original status.
Note: Press the RESET button will erase the
clock and stored stations.
Install the unit
Important:
Remove the two screws on the top of the unit
before installation.
Otherwise, the player will not work.
Installing the panel
• Hold the panel and ensure the panel faces
dwonward, and at an angle set one side of
the panel in the panel bracket. Press the
other side of the panel until it locks.
• Press the top of panel until it locks.
— — — — — — — — — — — — — — — — — — — —
Installation Opening
This unit can be installed in any dashboard
having an opening as shown below. The
dashboard should be 4.75mm - 5.56mm thick
in order to be able to support the unit.
1. Inset mounting collar into the dashboard,
and bend the mounting tabs out with a
screwdriver.
Make sure that lock lever is flush with the
mounting collar (not projecting outward).
2. Secure the rear of the unit.
After fixing mounting bolt and power
connector, fix the rear of the unit to the car
body by rubber cushion.
3. Insert trim plate.
Mounting bolt
Rubber cushion
— — — — — — — — — — — — — — — — — — — —
Removing the unit
1. Switch the power off.
1. Remove the panel and the trim plate.
2. Insert both T-Keys into hole on the front
of the set until they lock.
3. Pull out the unit.
Reset
