3.3.1
Switching Settings
This pane provides configuration options for the L2 Switching mode and for the MAC address
aging period.
To access the Switching Settings pane
1.
Click the
Backbone
menu option and choose
Switching
and then
Switching Settings
from
the sub-menus. The Switching settings pane is displayed.
2. Define the required parameters according to the following descriptions and click
Apply.
Field
Description
Current/Configured
Switching Mode
This parameter defines the traffic forwarding method:
L2 Switching
mode: traffic flooding is enabled.
To dynamically learn about station locations, the Base Station listens to incoming
frames and keeps a table of address information by inspecting the source MAC
addresses. If the source MAC address is not in the address table already, it is
recorded in the table.
As a part of the forwarding decision, if destination MAC address is found, the
frame can be forwarded to that address. If the address is not found in the table,
the frame is flooded to all the CPEs (if it's a downlink packet) and to the CPEs
and network interface (if it's an uplink packet).
Forward-to-router
mode (
To be used for testing purposes only!!!
): all traffic is
forwarded to the upstream router (no flooding). Do NOT use it.
Values: [L2 Switching; Forward-to-router]
MAC address Table
Aging Time
(300…1800) [sec]
Mac Address Table Aging period (in seconds), after which unused MAC address
entries will be dropped.
Values: 300-1800
© CalAmp Sentry 4G-900 Pico Base Station
14
