001-5006-000_FCC.docx
Page 36
Chan
Chan displays the frequency channel pair.
Rx Frequency
Rx Frequency displays the receive frequency for the channel pair.
2-18
001-4006-101
Tx Frequency
Tx Frequency displays the transmit frequency for the channel pair.
Power
Power displays the Power Output Adjust value for the channel pair. The default value is 255 (5 watts).
This
value should be left at the default value unless:
�
a lower power is required to meet regulatory requirements or
�
the user‟s application requires an increase in the transmit duty cycle
Default Freqs
The Default Freqs button forces the Rx and Tx Frequencies to their default values, based on radio type
and
range.
2.5.5 VERSION REQUEST
Selecting Version Request causes the GUARDIAN Field Programming Software to display information
about the
version of the GUARDIAN hardware and firmware.
Figure 2-13 Version Request Screen
2.5.6 WRITING / READING GUARDIAN PARAMETERS
After all radio parameters are setup, select the OK button to store the information into the PC‟s
memory. To load parameters into the GUARDIAN, initiate a Write Programmable Settings from the
Edit menu or select the Write icon from the Tool Bar
.
After the programmable parameters are
loaded into the GUARDIAN, save the parameter information using the Save Data As option in the File
pull-down menu.The name and location of the file (*.dat extension) will appear on the status bar at the
bottom of the screen.
The Read Programmable Settings command will read parameters from the current GUARDIAN and
store the information in local memory. The parameters can be viewed and/or edited with the
Setup Modem/Radio Parameters screens.
2.02
2-19
001-4006-101
Note: Dataradio recommends a Read be done anytime an initial connection is made to the GUARDIAN
Setup
Port before accessing the Setup Modem/Radio Parameters screen. This will help avoid writing erroneous
parameters to the connected unit.
2.5.7 CLONE PROGRAMMABLE PARAMETERS
