•
Use of drill
bit stops is highly recommended.
•
After drilling, remove all metal shavings before installing screws.
•
Do not overtighten self-tapping screws.
1.
Once you have found a suitable mounting position for GeminiG3 radiomodem, hold the unit and the unat-
tached mounting bracket in the proposed mounting position and check that there is clearance behind the
unit for the heatsink, cables, etc. Check that the position provides a large enough flat surface that the
bracket will not be distorted when installed.
Exterior Dimensions:
6.3 x 2.5 in. -
Slot Dimensions:
1.0 x 0.2 in.
Figure 1 - Mounting plate and slot dimensions
2.
Using the installation bracket as a template, mark the four locations for drilling (see Figure 1). Again, en-
sure that drilling at the selected points is safe and will not cause damage.
3.
Indent the drilling positions with a center punch. Drill holes sized for the self-tapping screws or for the
nuts, bolts and lock washers used.
Figure 2 - Bracket installation
Caution:
Slightly reduce the size of the drilled holes when using self-tapping screws in thin metal.
4.
Install the bracket without distorting (see , bolts and lock washers used.
5.
Figure 2 - Bracket installation
12