Cal Flame BBQ07877P, Руководство пользователя

Страница: 8 / 16

Page 6 2007 Pizza Oven Owner’s Manual
LTR20071039, Rev. A
Installation / Assembly
Your Cal Flame™ pizza oven is designed for easy
installation into a non-combustible enclosure. The
supporting deck or counter must be flat and level.
When determining the final location of your pizza oven,
adequate cross ventilation must be present to prevent
gas from being trapped in the event of a leak.
The drawing at right shows the cut-out dimensions for
the drop-in pizza oven.
Before installing a drop-in pizza oven in any island or
cut out, make sure that the opening is not bigger than
the outside frame of the pizza oven. The pizza oven
should rest on the lip of the frame.
Pay careful attention to the location of gas lines. Gas
lines should be routed away from sources of heat and
should make as few bends as possible. Check to see if
gas line connections will be accessible when the pizza
oven is installed.
If gas line connections are not easily accessible when
the pizza oven is installed, support the pizza oven
above counter level and attach the gas lines. When the
gas connections are made, slide the pizza oven into
the cut out.
If gas line connections
are accessible when
the pizza oven is
installed, slide the
pizza oven into the
cut out and then
attach the gas lines.
Be very careful not to
kink gas lines when
lowering the pizza
oven into the cut out.
You will need a
second person
to help you to avoid damaging your pizza oven or
barbecue island.
Keep your fingers away from where the pizza oven will
be supported on counter. Your fingers could become
trapped and serious injury could occur.
Check to make sure the pizza oven is level and is
supported around the entire outside edge. If the pizza
oven is not level or is unstable, use non-combustible
shims under the outside lip to stabilize it.
Width Depth Height
17 ½” 23 ¼” 9 ½”
Installing the Bricks and Rack
The pizza oven uses three white bricks for diffusing
heat from the burners.
After you have removed the pizza oven from the box
and removed all packing materials, place the three
racks lengthwise on the left and right ledge above the
burner. Then place the three white bricks on the racks
in the same way.
Remove the packing material from the rack and slide it
in place on top of the bricks.
Installing the Pizza Oven in a Barbecue Island