Cal Flame BBQ07877P, Руководство пользователя

Страница: 12 / 16

Page 10 2007 Pizza Oven Owner’s Manual
LTR20071039, Rev. A
Appendix
Appendix
Troubleshooting
Problem: Smell of gas is present
Solution:
Check for loose connections in the gas line. Perform a leak test following the procedure described in
this manual.
Problem Burner does not ignite
Solution
Use the following procedure with the figure below.
Check the position of the sparker tip. It should be pointing forward towards the front of the burner.
Make sure there is a blue spark at the electrode tip to the burner.
Make sure the igniter wire is connected firmly to the valve ignition device and the electrode.
Make sure the valve orifice is free of any debris, dust or grease.
Make sure the valve orifice is aligned inside the front hole of the burner.
If there is no spark at all, replace the electrode or igniter wire.
Note: Turn off the gas at the source while troubleshooting.
•
•
•
•
•
Problem: Burner tube is misaligned over the orifice
Solution: Reposition the burner tube so that it is properly seated over the orifice.
Problem: Obstruction in the gas line
Solution:
Remove the fuel line from pizza oven. Open the gas valve for one second to blow out any debris.
Close off the gas valve and reconnect the fuel line securely.
Problem: Yellow Flame
Solution:
Once the entire burner is operating, check the flame color to be sure that it is mostly blue. Some
yellow at the tips may be present due to impurities in the fuel. If the flame is golden or yellow in
color, the reason could be seasoning salts, oil film, or other foreign matter on the burner.
Problem: Misalignment of Igniter on Burner
Solution:
Check for proper position of the electrode tip, which should be pointing forward towards the front
of the burner and free of grease to allow proper sparking.
The ignition wire should be connected firmly to the valve ignition device and electrode. Replace
the ignition wire if it is frayed or cracked.
With the gas supply closed and the control knob set to the off position, check the position igniter
for the presence of a spark at the electrode. Push the knob in fully and rotate it about 1/4 turn to
the left (counter-clockwise) until you hear a loud click. The trigger hitting the strike block should
produce a blue spark at the electrode tip. Return the control knob to the OFF position.
While the pizza oven is still hot, wait for a minimum of five minutes before relighting. (This allows
accumulated gas fumes to clear.) If all checks / corrections have been made and the pizza oven
still fails to operate properly, contact your local Cal Flame dealer.
•
•
•
•