Troubleshooting:
Circuit Layout
Installing The Unit:
1.
Lay box down on the back and cut open the bottom from the straps. The wheels will be located in a smaller box
inside of the unit’s box. Open the box of wheels and there should be 4-wheels and 16 screws. Check to make
sure that all parts are present.
2.
Use a screwdriver, gently screw on the wheels and make sure not to strip the screws.
3.
Stand your box back up and remove the box from the unit by lifting it over the top. Make sure that all parts are
intact and correctly assembled.
4.
You may begin filling water through the water inlet flap using regular tap water. There is a water level in the
front of your unit, located on the reservoir. Be sure not to fill past the “H”, HIGH, level. You will not see the
water until it reaches half of the tank on “L”, low, but this level may not need to be reached for your
preference. Filling at half of the tank will last at least 4 hours of run time.
5.
If hooking the hose to the hose attachment, be sure that the hose is using low pressure. There is a “float”
inside of the water reservoir to stop the water flow when the reservoir becomes full. Hose attachment
accessory is in your manual packet.
6.
Plug in the unit to a safe outlet, and begin using your fan by pressing the Power button. Choose your suitable
speed for your unit and begin enjoying.
