Caen RFID easy2read qID R1240IE, Техническое руководство

Страница: 15 / 30

CONFIGURATION
- qID Technical Information Manual 15
3 CONFIGURATION
Configuration file
The qID.cfg file (in the CONFIG directory) is the reader's main configuration file.
Using this file you can configure the following reader options:
 Auto shutdown : Enable or disable the reader's automatic shutdown. By default the auto shutdown is ON and if
the reader is power on, after 5 minutes of inactivity, it enters in standby mode, starts blinking and loses the
connection. To allow the reader to remain power on and Bluetooth/USB connected, disable the auto
shutdown function in the configuration file.

Power down time
: Set the number of seconds(from 1 to 86400) of inactivity required before starting the
automatic shutdown procedure. By default, the power down time is set to 300 seconds.
 Power LED Blink : Enable or disable power LED blinking during stand-by. By default the power LED blink is ON, so
when the reader enters in standby mode, it starts blinking and gives information about the battery level.
Status Description
Steady green Reader is active and battery if fully charged
Blinking green Reader is in stand-by and battery is fully charged
Steady orange Reader is active and battery is discharging
Blinking orange Reader is in stand-by and battery is discharging
Steady red Reader is active and battery is almost empty
Blinking red Reader is in stand-by and battery is almost empty
Tab. 3.1: qID R1240IE/IU Power LED Status Table
 Successful beep time : Set the number of milliseconds (from 1 to 60000) the reader beeps upon successful
inventory. By default, the s uccessful beep time is set to 400 milliseconds.

Unsuccessful beep time
: Set the number of milliseconds (from 1 to 60000) the reader beeps upon unsuccessful
inventory. By default, the unsuccessful beep time is set to 400 milliseconds.

Proximity Sensor : Enable or disable the proximity sensor. The proximity sensor is the equivalent of the button
and has its own features. It is useful in applications where the use of the button is difficult. By default, the
proximity sensor is set to OFF.

Vibration
: Enable or disable the reader's vibration (only for use with button or proximity sensor). The vibration
informs you that the read operation is successfully completed. By default, the vibration is set to OFF.
 TCL script : Select the TCL script to be executed among those stored in the SCRIPTS directory when the SCAN
button is pressed (in the last line, the value assigned to tcl_script variable represents the script to be
executed, by default the c1g2inv.tcl ). For more information, please refer to § Scripting capability page 17.