Cadac CDC seven, Руководство пользователя по оборудованию

Страница: 39 / 50

Revision 1 2017 CDC seven
39
Channel blocks:
Touching a channel block opens a virtual panel with all controls relevant to the
block.
Mic Pre
EQ section
Dynamics section
Routing
Virtual Bargraph Meter Pan
Touching in any of the areas shown
above will open the corresponding
virtual panel. The specific channel
functions are described in the
Software Manual.
Panels open on the right-hand edge
of the display so that the functions
in the panel are controlled by the
adjacent right encoder set.
The vertical (right) set of encoders
has no function until a panel is
opened. However, the horizontal
(lower) set of encoders is always
active, and by default, are assigned to
act as the coarse input gain controls
for the currently displayed channel
set. If a digital input is patched to an
input channel, its lower encoder acts
as a gain trim control. By default,
opening an EQ panel will re-assign
them as EQ controls while the panel
is open, but it is possible to move the
EQ panel to the right-hand side of
the screen so that EQ adjustment can be made by the vertical encoder set. By
pressing the Swap button, the lower set of encoders may be reassigned as input
channel pan controls (or matrix output time delays), though in this case, panning
(or delay) has to be enabled for the channel before its lower encoder is active.
Note that opening a dynamics panel will always reassign them as controls for the
channel dynamics section while the panel is open.
Example – Input Gain block:
SWAP SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL SEL COPY ISO
The various panels are designed so that
each variable parameter is displayed
immediately next to the encoder that
adjusts it. The diagram above shows how
five of the 12 encoders are assigned to the
five parameters available for control. All
switch functions are actioned by directly
touching the screen. Any function which is
unavailable for some reason (e.g., an input
needs to be assigned to an input port
before it can be used) is greyed-out. All
panels are closed by the familiar red button
with a white cross.