Installing the Transceiver Tap
ST-500 INSTALLATION GUIDE
Page 2-7
Figure 2-6. Installing the Center Probe
7.
With the center probe installed, the transceiver case can be
attached to the tap. Remove the two flat-head screws from the
transceiver case and insert the tap into the rectangular opening in
the case. Make sure the tap pins are aligned with the connector
block on the transceiver circuit board.
Caution:
Avoid forcing the tap into the case. Very little force is needed.
If the tap does not seat easily, remove it to determine the cause of the
obstruction.
8.
Insert and tighten the flat-head screws shown in Figure 2-7.
CENTER
PROBE
CORING
TOOL
CABLE
BED
